
ServicesSliding Door Replacement
Sliding Door Replacement in South San Jose Hills
A sliding door that sticks, whistles in the wind or refuses to latch is usually worn past adjusting. We pull the whole unit, frame included, and install a new door that glides with a light push. It seals tight, locks every time, and we clean up before we go.
When a New Sliding Door Makes Sense
A sliding door takes more abuse than any window in your home. It gets opened dozens of times a day, the bottom track collects dirt, and the rollers wear flat. After enough years the frame itself bends or corrodes, and new rollers stop helping.
Many homes around here still have the original single-pane aluminum slider. Those frames conduct heat straight through, and the track wears into a groove. Replacing the whole unit fixes the drag, the drafts and the hot glass in one job.
We are CSLB C-17 licensed and have been in business 12 years. On a door job we look at the opening, the floor and the framing first, then tell you plainly what the new door needs.

What We Do on a Sliding Door Job
- 01
Taking accurate measurements
Older openings rarely sit perfectly true. We take readings at the top, middle and bottom, side to side and floor to header. Those numbers tell us if a stock size fits or if your door has to be made to order.
- 02
Pulling the old unit
The panels lift out first. Then we cut the old frame free and work it out slowly so the stucco and drywall around it take as little damage as possible.
- 03
Looking at what's underneath
Once the old frame is out, the subfloor and nearby wood are in plain view. If there's water damage, we show it to you before the new door goes in.
- 04
Leveling and sealing the frame
We shim the frame until it's plumb and level, fasten it, and seal the sill and jambs so rain runs away from the house. A true frame is what keeps the panel gliding year after year.
- 05
Title 24 glass
Every new door comes with dual-pane, low-E glass that meets California's Title 24 energy rules. All panels are tempered safety glass.
- 06
Finishing and haul-away
We put the trim back on inside and out, adjust the rollers and latch, and haul off the old door and every scrap of debris.
Questions about Sliding Door Replacement?
Call(626) 654-3121Signs It's Time for a New Sliding Door
You have to put your weight into it
Flat rollers and a bent track make the panel fight you. If fresh rollers didn't fix it, or the track has a worn groove, the frame is what's failing.
Cloudy glass you can't wipe clean
Haze or droplets between the panes mean the seal has broken. That fog stays put.
The latch misses
As a frame settles or warps, the lock no longer meets its catch. A slider you can't secure is a safety concern, not a small nuisance.
Grit and air coming in at the edges
Gusty, dry fall winds force dust past tired weatherstripping and gaps where the panels meet. Weekly track sweeping means the seal has worn out.
Glass that radiates heat
Old single-pane aluminum sliders let the sun's heat straight through. Stand next to one on a summer afternoon and you'll notice.
How a Door Job Runs
- 1
Free in-home estimate
We come by, measure the opening, look over the track and framing, and talk through door styles and glass with you. The price is written down for you, with no pressure and no obligation.
- 2
Placing the order
Once you pick a door, we order it made to your opening. If the job needs a permit, we pull it.
- 3
Installation
Before any tools come out, we lay protection over your floors. We remove the old panels and frame and set the new door in place. One door usually takes a single day, and your home is locked up again before we leave.
- 4
Final check together
We slide the door open and shut with you, try the latch and the screen, and share a couple of simple habits for keeping the track clean so the rollers last longer.
What Sets the Price of a New Slider
Each sliding door is priced from the opening we measure at your home, not from a chart. You get a written number after the estimate. If you already hold an estimate from a licensed contractor or a USA-made window supplier, show it to us and we'll beat it.
- Width and number of panels
- A two-panel door is the simplest setup and costs the least. Three or four panels across a wide opening push the price up. Extra-tall or odd-width openings mean the door has to be built to order.
- What the frame is made of
- Vinyl is what most people choose. Fiberglass and some aluminum frames cost more, but they give you slimmer sightlines or a different look.
- Glass choices
- The cost of each panel changes with what you put in it: low-E coatings, laminated glass or blinds sealed between the panes.
- Condition of the sill and framing
- If the sill or wood framing has rot, it gets fixed before the new door is set. You see what we found and hear what it takes before any extra work begins.
- Stucco and patching
- Some new frames fit inside the old opening. Others need the stucco cut back and patched once the door is in, which adds labor.
Sliding Door Questions
Can you just replace the glass or rollers instead?
We do full door replacement, not part swaps. If the frame is straight and sound, a roller swap from a parts supplier may get you more time. When the frame is bent, corroded or single-pane, a new door is the fix that lasts.
How long will my door opening be open?
Usually only a few hours. We take out the old door and set the new one the same day, so your home is locked up by evening.
Do I need a permit for a new sliding door?
Often yes, especially if the opening size changes. We find out what your city or county requires and pull the permit when one is needed.
Can I make the opening wider?
Sometimes. Widening a wall means checking the header and the framing above it. We look at that during the estimate and tell you straight if it's practical.
How fast can you come out?
We offer free same day estimates when the schedule allows. We'll measure, answer your questions and leave you a written price.
Who does the install?
Our crew brings 30 years of window installation experience to every job, and that same care goes into setting door frames level and sealed.

Ready for a Door That Rolls Easy
We'll come out, measure your opening and give you a written price. No pressure, and nothing to sign on the spot.