Skip to content

We measure every opening at your free in-home estimate: (626) 654-3121

(626) 654-3121
Installer in a dark hoodie and tool belt pressing flashing tape around a new white vinyl window set in a wrapped stucco wall opening, with a red stepladder nearby

ServicesWindow Installation

Window Installation in South San Jose Hills

Need a window in a blank wall, or a small one made bigger? We cut and frame the opening, flash it right, set the new window, patch the stucco and take care of the permit. The room gets more light, and the wall stays dry.

New windows in new openings

Window installation is a different job from trading an old unit for a new one. We're opening up a wall, building a header and setting a window that has to hold back rain and dust for decades. It usually comes with room additions, ADUs, garage conversions and kitchen remodels.

Most houses around here are stucco over wood framing, and that changes how the job goes. A new opening means a clean stucco cut, new paper and flashing woven into the old layers, and a patch that sheds water like the rest of the wall. Miss a step and the first wet winter tells you.

Our company holds a CSLB C-17 license, and the hands on your job have 30 years of window installation experience. If you just want new windows in the same openings, our window replacement or window retrofitting pages fit better.

What the job includes

Layout and framing check

We find the studs, wires and pipes before anything gets cut. Then we mark the opening so it lines up with the room and the outside of the house.

Header and rough opening

A new or wider opening needs a properly sized header to carry the load above it. We frame it square and level so the window operates smoothly for years.

Flashing and weather barrier

We lap new building paper and flashing tape into the existing layers, sill first, then sides, then head. This is the part that keeps water out of your wall.

Setting and sealing the window

The window goes in plumb, shimmed and fastened per the maker's instructions. We seal the gaps with low-expansion foam and caulk.

Stucco and drywall patch

We patch the stucco around the new opening and close up the inside wall. It's left ready for paint.

Permit and energy paperwork

New openings usually need a building permit, and new glass has to meet California's Title 24 energy rules. We pull the permit and pick windows that pass.

When window installation is the right call

  • You're adding a room or ADU

    New walls need new windows. We work with your builder's schedule or handle the openings on our own.

  • A garage is becoming living space

    Converted garages usually need windows for light, air and code. We can set them in the old wall or a new one.

  • A bedroom needs an egress window

    Sleeping rooms need a window big enough to climb out of. If yours is too small, we can enlarge the opening to meet code.

  • A room is just too dark

    Plenty of older ranch houses have a hallway, den or kitchen with one small window or none. A new opening on the right wall changes how the room feels.

  • Your remodel moves things around

    Moving a sink or rearranging a kitchen often means a window has to move, shrink or grow. We close up the old spot and open the new one.

How the work goes

  1. 1

    Free in-home estimate

    We stop by, check the wall inside and out, and take measurements. You hear plainly what the opening will take, with no sales pressure and no obligation.

  2. 2

    Written estimate and permit

    Your written estimate lists the window, the framing and the finish work. Once you give the go-ahead, we pull the permit and order the windows.

  3. 3

    Cut, frame and flash

    On install day we cover floors and furniture near the wall. We cut the opening, build the header and get the weather barrier in place before the window goes in.

  4. 4

    Set, patch and inspect

    We set and seal the window, patch the stucco and drywall, and clean up the dust. The job isn't done until the inspector signs off.

What sets the cost of a new opening

No two openings cost the same, because the wall itself drives most of the labor. We check it from inside and outside before we give you a number. Your written estimate lists the window, the framing and the finish work as separate lines, so install day brings no surprise charges.

Solid wall or existing window
Cutting into a solid wall takes more framing than widening a window that's already there. A bearing wall also calls for a heavier header than a partition wall does.
Window size and style
A large picture window or a slider costs more than a small single-hung. Arched tops and odd shapes add to the total.
Stucco and finish work
More stucco to cut and patch means more labor. Heavy textured finishes take extra time to blend in.
Glass package
Title 24 sets the floor for energy performance. Better low-E coatings or laminated glass cost more, but they block more summer heat.
Access and height
Second-story openings and tight side yards need ladders, staging and longer setup. Ground-floor walls with clear access go quicker.

Window installation questions

Something not covered here? (626) 654-3121

Do I need a permit to add a new window?

Most of the time, yes. Cutting a fresh hole in a wall, or making an old one bigger, affects how that wall carries weight, so the building department wants to review it. We pull the permit and are there when the inspector comes out, so you aren't stuck chasing paperwork.

How is this different from window replacement?

Window replacement puts a new unit into an opening that already exists. Window installation builds the opening or changes its size, which means framing, flashing and stucco work on top of the window itself. We do both, and we'll tell you which one your project really calls for.

How messy is cutting into a stucco wall?

There's dust, and we plan for it. We cover floors and furniture, seal off the work area inside and clean up at the end of each day. Most single openings get cut, framed and set in one day, with the stucco patch and inspection after.

Can you make a bedroom window big enough for egress?

Usually, yes. We check the framing and what sits above the window, then size the opening to meet the egress rules for clear width, height and sill height. If something inside the wall makes that tricky, we'll show you before any cutting starts.

How long have you been doing this?

Our company has 12 years in business, and the crew setting your windows brings 30 years of window installation experience. We put windows into homes across South San Jose Hills, West Covina, Hacienda Heights and the towns nearby.

Will you coordinate with the builder on my addition?

We will. If your framer builds the rough openings, we set the windows into them. If not, we frame the openings ourselves. Give us the timeline early so the windows are in and flashed before stucco and drywall start.

Single-story stucco house with white-framed windows on both sides of a black glass entry door with sidelites, shrubs, curved walkway, and a toolbox and bucket on a drop cloth.

Planning a new window?

Tell us about the room and the wall. We'll come look, measure and give you a written price with no pressure to sign.